Note: These adjustments usually require removing a side panel or accessing a "trap door" on the unit. They are engineering controls.
If you are performing maintenance on the BFS-300, you may encounter these trim-potentiometers (pots): ikegami bsf-300 manual
Calibration Procedure:
The Ikegami BSF-300 offers a range of output formats, including: Note: These adjustments usually require removing a side
Troubleshooting and Maintenance
| LED/Code | Meaning | Troubleshooting | |----------|---------|------------------| | ALARM + CARRIER off | No triax connection | Check cable continuity, BNC center pin | | CAMERA off, CARRIER on | Camera not powered | Check camera’s power switch; measure +12V at camera end (pin 2 & 3) | | ALARM blinking | Overcurrent on triax | Short in cable or camera. Disconnect, measure resistance (should be >1kΩ between shield & center) | | VIDEO LED off | No video from camera | Reseat camera module; check lens cable; cycle power | | LCD shows "E-4" | Genlock signal missing | Apply Black Burst; check termination (75Ω) | Calibration Procedure: The Ikegami BSF-300 offers a range
