Mks Laser Tool Setup V1 1.2 Exe Download May 2026

Yes, but you must use firmware version 1.15 or earlier. Newer DLC32 v2.1 boards with firmware 1.16+ may not fully work; use MKS Laser Tool v1.2.6 instead.

Once installed, you must link the software to your physical laser controller. Here’s a typical configuration for an MKS DLC32 or similar board.

Even with proper installation, users hit roadblocks. Here are the top issues and fixes. mks laser tool setup v1 1.2 exe download

You can also visit the official Makerbase website (makerbase.top). Navigate to the "Download" or "Support" section and search for the Laser Tool software.

If the specific V1 1.2 link is not immediately visible on the main page, check the "Previous Versions" section in their GitHub releases. Yes, but you must use firmware version 1

Makerbase hosts all their drivers, firmware, and software on their official GitHub page.

The installer includes an option to install CH340 and CP210x drivers. If you skipped it, download the drivers separately from the manufacturer. Once installed, you must link the software to

Note: Direct download links change over time. Always verify the URL and checksum if provided.

Once you have downloaded the MKS Laser Tool Setup V1 1.2 EXE, follow these steps:

Install: Click "Install" and wait for the process to finish.

Launch: Once complete, launch the MKS Laser Tool.