Only after confirming correct sensor reading, wire the load through the output device (SSR or contactor).
Secure the controller to the panel or DIN rail. Leave slack in wires to avoid pulling terminals.
BendixKing KT 70 Installation Manual (Part Number 006-00673-0002
) is the official technical guide for integrating this Mode S transponder into an aircraft. Core Installation Highlights Kt 70 Installation Manual
The manual typically covers the following critical sections for a successful setup: General Information:
Provides technical specifications, including power requirements (11-33VDC, 35W max) and environmental limits (-20° to +55° C). Installation Procedures:
Detailed instructions on securing the mounting tray and sliding the unit into place. System Interconnect: Only after confirming correct sensor reading, wire the
Includes wiring diagrams and pinout definitions essential for connecting power, ground, and data lines. Post-Installation Checkout:
Steps for configuration, calibration (such as display brightness adjustments), and functional testing. Key Technical Specs Operating Modes:
Standby (SBY), Test (TST), Ground (GND), On (ON), and Altitude (ALT). Altitude Reporting: Supports reporting up to 50,000 ft. Programmable Features: Secure the controller to the panel or DIN rail
Includes a non-volatile VFR code (default 1200 for USA or 7000 for Europe). Display Adjustments:
Three programmable settings (dA 1, dA 2, dA 3) for response time and brightness levels. Where to Find the Full Manual
Since this is legacy equipment, official physical copies are often found through third-party vendors or documentation services: Aero-Stuff / Aircraft Maintenance Manuals: Offers the KT 70 Installation Manual (Manual #006-00673-0002) for purchase. Hosts digital versions, such as the KT 70 Maintenance Manual (Rev 3), which contains overlapping technical data. BendixKing Support: You can search their official downloads portal for updated service bulletins or related documentation. mounting tray diagram for your installation?