You need Icom CS-F2000 programming software (paid, from an Icom dealer) plus a USB programming cable like the OPC-478UC or a quality clone from BlueMax49ers or Valley Enterprises.
The official programming software for the IC-F2000 is called CS-F2000 (Cloning Software for F2000). The "full" version typically refers to the commercial license that Icom provides to dealers and authorized service centers.
If you’ve just picked up an Icom IC-F2000 (often called the ICF2000) — a rugged, submersible marine VHF — you might be hunting for programming software. Let me save you some trouble.
Assuming you have obtained the legitimate full version (either from Icom directly or via authorized dealer distribution), follow these steps:
Step 1: Driver Installation Do not plug the cable in first. Download the driver for your USB-to-Serial adapter. Install the driver, then plug in the cable. Note the COM port number (e.g., COM3) in Windows Device Manager. icom icf2000 programming software full
Step 2: Software Installation
Run the installer (usually Setup.exe). The full version does not require an internet activation key in most legacy cases, but modern versions may require a license key provided by Icom.
Step 3: Launching the Application Open the software. You will see a blank spreadsheet-style grid.
Step 4: Configuring COM Ports
Go to Settings > Communication Port. Select the COM port you noted in Step 1. Set speed to 9600 bps (default for ICF2000).
Step 5: Reading the Radio
Turn the ICF2000 ON. Click Read (or Receive). The software will pull the current configuration from the radio. Always do this first to save a factory backup. You need Icom CS-F2000 programming software (paid, from
Step 6: Programming Channels In the grid:
Step 7: Writing to the Radio
Click Write (or Send). Do not turn off the radio or unplug the cable during this 15-second process.
Assuming you have legally obtained the full software:
Before we discuss the software itself, it is critical to understand the difference between demo/trial software and the full version. Step 7: Writing to the Radio Click Write (or Send )
Searching for the "full" version usually means you want to bypass shareware limitations and gain administrative control over the radio.
Searching for “ICF2000 programming software full” leads to sketchy forums offering cracked copies. These often:
I’ve seen two radios completely bricked by bad “free” software. Recovery required sending the unit to Icom ($150+ bench fee).
The official programming software for the Icom IC-F2000 series is called CS-F2000.