Firstchip Fc1178 Fc1179 Mptools V1052 Repack May 2026

If you have ever plugged in a cheap USB flash drive—one bought in bulk from an online marketplace or given as a promotional gift—you have likely encountered the dreaded "0 MB" capacity error or the infamous "Please insert disk into drive" message. In most cases, the culprit is a corrupted firmware or a logical bad block map inside the FirstChip controller.

Two of the most common controllers found in these budget drives are the FirstChip FC1178 and FC1179. The only reliable software solution to revive these drives is a specialized version of Mass Production Tool (MPTool). Enter the legend: FirstChip FC1178 FC1179 MPTools v1052 Repack. firstchip fc1178 fc1179 mptools v1052 repack

This article dives deep into what this tool is, why the "repack" matters, how to use it safely, and how to troubleshoot common errors. If you have ever plugged in a cheap

A new tab titled "Rescue" is added to the top bar. A new tab titled "Rescue" is added to the top bar

+-------------------------------------------------------+
|  FirstChip MPTools v1052 [Repack Edition]             |
+-------------------------------------------------------+
| [Setup] [Flash ID] [Rescue] [Settings]               |
+-------------------------------------------------------+
|                                                       |
|  Detected Device: USB Mass Storage (FirstChip)        |
|  Controller: FC1178                                   |
|  Port: #1                                             |
|                                                       |
|  [ Status: READY ]                                    |
|                                                       |
|  (x) Quick Format (Low Level)                         |
|  ( ) Full Scan & Repair (Slower, fixes bad blocks)    |
|                                                       |
|  [  START AUTO-REPAIR  ]                              |
|                                                       |
|  Progress: [####################] 100%                |
|  Log: Writing config block... Done.                   |
|        Verifying capacity... Done.                    |
+-------------------------------------------------------+

Even with v1052 repack, you will hit walls. Here is the technician's cheat sheet.

| Error Code | Message | Likely Cause | Fix | | :--- | :--- | :--- | :--- | | 0x104 | Download ISP Fail | Voltage mismatch or bricked NAND | Short the two TEST pins on the PCB (Google: "FC1178 short pin method") | | 0x110 | Bad Block too many | The NAND is truly dying | Run "Erase All Block" in Setting → "Test Mode" . Reduce total capacity to 50% in Capacility Setting. | | 0x303 | Compare Flash ID Fail | The tool's DB lacks your exact NAND | Manually edit FlashDB.ini in the repack folder. Add NAND ID parameters from a working dump. | | Write Protect | N/A | FC1179 entered hardware lock | You cannot fix this with software. Requires JTAG/shorting. | | Time out | 0x217 | USB power saving | Disable "USB Selective Suspend" in Windows Power Options. |

Hintergrund