Manual — Fagor Fi-80 Dishwasher

The FI-80 typically features a recessed handle and a top-mounted control panel with buttons and indicator LEDs. Without the manual, decoding the symbols is tricky. Here is a breakdown based on the official documentation:

| Symbol / Button | Function | |----------------|----------| | Power | Turns the dishwasher on/off. | | Program Selection | Cycles through: Intensive (70°C), Normal (55°C), Eco (50°C), Glass (45°C), Rapid (40°C). | | Half Load | Reduces water consumption when washing in only the upper or lower basket. | | Extra Drying | Activates a heating element during the final rinse for plastic items. | | Delay Start | Allows you to delay the start by 3, 6, or 9 hours. | | Salt / Rinse Aid Indicator | LED lights up when you need to refill the water softener or rinse aid dispenser. | fagor fi-80 dishwasher manual

| Code | Meaning | |------|---------| | E1 | No water / slow fill | | E2 | Not draining | | E3 | Heater fault | | E4 | Leak detected (flood switch) | | E5 | NTC temperature sensor fault | | E6 | Motor or tacho fault | The FI-80 typically features a recessed handle and

For E4 or repeated codes, disconnect power and contact Fagor service. The FI-80 uses a sequence of flashing indicator

The FI-80 uses a sequence of flashing indicator lights to communicate errors. Since there is no digital screen, the Fagor FI-80 dishwasher manual decodes these flashes as follows:

| Flashing Pattern | Error | DIY Fix | |----------------|-------|---------| | "End" light flashes rapidly | Water inlet failure (no water or low pressure) | Check that the water supply valve is fully open. Ensure the inlet hose isn't kinked. Clean the mesh filter inside the water inlet pipe. | | "Salt" and "Rinse Aid" LEDs flash together | Drainage issue (blocked pump or filter) | Clean the bottom filter and the drain hose. Check the kitchen sink’s air gap. Remove any food debris from the drain pump impeller. | | "Intensive" light flashes | Heating element error | The water is not reaching temperature. This often requires a technician to replace the heating element or thermistor. | | All program lights flash | Electronic control board fault or door latch failure | Try unplugging the machine for 10 minutes to reset the board. If it persists, check the door microswitch. |

A: No. The manual explicitly warns against table salt (NaCl with iodine or anti-caking agents). These additives destroy the water softener resin. Use only coarse dishwasher salt.