snmp-server community public ro
snmp-server community private rw
snmp-server host 192.168.1.200 traps version 2c public
snmp-server enable traps all
MINI-LINK# show radio performance hop 1
# Observe RSL is below threshold (-75 dBm). Check TX power:
MINI-LINK# show radio hop 1 tx-power
# Increase marginally if allowed:
MINI-LINK(config)# radio
MINI-LINK(config-radio)# hop 1
MINI-LINK(config-hop)# tx-power +3
# Re-check after 5 min
Ericsson MINI-LINK products use a command-line interface (CLI) based on a hierarchical structure, similar to other carrier-grade network devices (e.g., Cisco/Juniper). The CLI is accessed via SSH or serial console. The system is built on a Linux-based operating system (often EOS – Ericsson Operating System).
If the radio looks good but traffic isn't passing, check the Ethernet port status. ericsson mini link cli commands
show interface ethernet 1/1/1 status
Key details: Ensure the Link status is Up and verify the Speed and Duplex settings match your switch. A duplex mismatch is a silent killer of throughput. MINI-LINK# show radio performance hop 1 # Observe
MINI-LINK# show vlan # Configured VLANs
MINI-LINK# show qos queue # Queue occupancy, drops per class
MINI-LINK# show ethernet oam # CFM, SLM, LM stats
test radio loopback local 1
# Enable local loopback (radio interface)
test radio loopback remote 1